• 3-Fan Overhead Ioniser
  Neutralizes electrostatic charges on insulators and ungrounded conductors in a 61 cm x 152 cm coverage area.
• Fast Decay Times (<3 seconds at 46 cm)
  Discharges (removes) both positive and negative electrostatic charges within the coverage area.
• ±3 Volt Offset Voltage Balance
  Meets required limits of ANSI/ESD S20.20 (<±35 volts), ANSI/ESD STM3.1 and ESD TR53.
• Dedicated High Voltage Power Modules with Balance Control at Each Fan
  Allows each fan to be tuned to produce the optimum decay and balance in the coverage area.
• Sealed Plenum Air Flow
  Prevents contamination from being introduced to workstation.
• Steady State DC Emitters
  Spaced farther apart to prevent ion recombination, increase decay efficiency, and provide a broader coverage area of ionisation.
• Solid Tungsten Emitters
  Maintains sharp point for optimal ioniser performance.  Resists oxidation, melting and other damage that dulls the tip of the emitter 
• 9 Speed Fan (92 to 142L/s)
  Consistent performance at all speeds.  Low airflow may be used when working with small moving parts and components that may move with higher airflow.
• Shielded Bearings
  Retains lubricant and minimizes contamination in the work area.
• Stainless Steel Housing and Multi-Mount Stand
  Minimizes foreign objects debris, corrosion, and other contaminations when used in clean or sensitive areas.
• NIST Calibrated – Original Calibration Certificate can be Downloaded Here
  Calibrated with accepted procedures and standards traceable to the National Institute of Standards and Technology. For more information on the calibration of Desco Europe products, see Calibration.
• Request a Demo HERE
• No power cord included
  Choose from 200220 or 200225
• Made in the United States of America

*U.S. Patent 6,205,408

“Ionisers should be considered as a method for charge neutralization in cases where grounding cannot be achieved. These may include localized (bench) ionised air blowers, compressed air ionisers, spot ionisers, tape dispenser ionisers and total room ionisers.” “Air ionisation can neutralize the static charge on insulated and isolated objects by producing separate charges in the molecules of the gases of the surrounding air. When a static charge is present on objects in the work environment, it will be neutralized by attracting opposite polarity charges from the ionised air. Note that ionisation systems should not be used as a primary means of charge control on conductors or people. As with all ionisers, periodic maintenance will be needed to provide optimum performance.” (EN 61340-5-2 paragraph 5.2.9)

“Various feedback and auto balance techniques are available to ensure ioniser performance. … Providing a sensor for each ionising device can improve feedback control. Effective control can reduce the amount of necessary maintenance. (EN 61340-5-2 paragraph 5.2.9.2 Monitoring and feedback control)